2010 Dodge Charger Engine Light On

This is nothing to worry about.

2010 dodge charger engine light on.

If your dodge check engine light is on and you get code p0404 it means that your dodge exhaust gas recirculation egr valve is operating out of range. In some cases you need to pull over immediately to prevent damage while in others you merely need to tighten you gas cap next time you stop in order to reset the service engine soon light. The most recently reported issues are listed below. You can reset the.

Click a link to learn more about each one. A check engine light can indicate a broad spectrum of problems with your 2008 dodge charger. The purpose of the egr valve is to recirculate exhaust gases and send them back into the engine to lower the nox emissions. You should take your dodge to a qualified mechanic to have the problem looked at and if necessary repaired before you reset the light.

Follow scan tool manufacturer s operating instructions to access the diagnostic trouble. The connector may have a removable cover. Four problems related to check engine light on have been reported for the 2010 dodge charger. Turn the ignition on.

If it doesn t you may see a wrench light or the check engine light instead. Please also check out the statistics and reliability analysis of the 2010 dodge charger based on all problems reported for the 2010 charger. Connect scan tool to the 16 pin data link connector dlc located near the steering column. They are roughly ordered by importance which tends to be by color red amber yellow orange green blue gray but there are nearly 50 of them so be patient.

The throttle control warning light will normally light up briefly each time you start your vehicle and then go off. But if the light stays on or comes on while you re driving your car needs some love.